OZONE GENERATOR MODEL LAB2B

The ozone generator is a small air cooled unit specifically design for bench use incorporating function indicator, feed gas flowmeter and variable output control.
The generator comprises of a high voltage/high frequency power supply unit and an air-cooled corona discharge module housed in a mild steel epoxy coated enclosure.

ELECTRONIC POWER BOARD

The ozone generator incorporates a high voltage/high frequency power board designed for either intermittent or continuous operation.
The variation is manually adjustable by a control knob mounted on the front panel of the unit.
The unit has been designed to operate on various feed gasses such as dried air or oxygen and is capable of producing concentrations up to 10% volume.

OZONE GENERATOR MODULE

The module consists of a ceramic dielectric tube inside which is centralised a 316 SS electrode assembly supported at either end by P.T.F.E. end caps.
The ceramic is housed within a finned heatsink block which is cooled by fan assisted atmospheric air.
The complete module assembly can be easily removed and dismantled for general maintenance and cleaning.

FEATURES

Units can operate either under vacuum or at a maximum outlet pressure of 10 psig.
Units can be combined to give larger ozone outputs if required.
Operating and maintenance instructions including performance graphs.
Full twelve months warranty and technical back-up facilities available.

QUALITY ASSURANCE AND TESTING

All products tested with BS EN ISO 9002.:94 quality assurance procedures and each generator is subjected to the following test procedure.
1.Power board function test.
2.Power board load test for 24 hours in 40℃ test chamber.
3.Module pressure test.
4.Complete unit test for 24 hours.
5.Calibration test and output check.

TECHNICAL INFORMATION

OZONE OUTPUT:4.0 GM/HR (FEEDGAS:DRY AIR -60℃ DEWPOINT)
OZONE OUTPUT:10.0 GM/HR (FEEDGAS:100% OXYGEN)
FEED GAS FLOWRATE:4-10 LTR/MIN AIR 2-5 LTR/MIN OXYGEN
OPERATING METHOD:VACUUM OR PRESSURE (10 psi max.)
MODULE COOLING MEDIUM:AMBIENT AIR (FAN ASSISTED)
VARIABLE OUTPUT CONTROL:15-100%

POWER SUPPLY:230V-1PH-50HZ OR 115V-1PH-60HZ
POWER CONSUMPTION:105 WATTS
CONNECTIONS:PVDF COMPRESSION FITTING TO SUIT 8mm OD PIPE
WEIGHT:6 KG

CONTROLS & INDICATIONS

OZONE ON-OFF:GREEN ILLUMINATED SWITCH
FAULT:RED ILLUMINATED INDICATOR
FLOWMETER:2-10 LTR/MIN